Blackhawk B6350: features, fit and setup

The B6350 provides a 3.5-ton rated capacity and a swivel saddle for positioning. Consider it for a suitable service setup when the lifting task requires that capacity.

By GearMyRide Editorial Team · November 17, 2026
Research-based advice · How we pick

Blackhawk B6350

The 3.5-ton rating does not establish underbody fit or replace jack stands. Confirm the lift and support arrangement before choosing it.

SpecificationDetail
Rated capacity3.5 tons / 7,000 lb
Saddle diameter4 inches
Body size28.5 × 13.75 × 6.5 inches
Load controlUniversal joint; internal safety valve

We may earn a commission from qualifying Amazon purchases.

See Blackhawk B6350 at Amazon

Will a floor jack fit—and where will the stands go?

Buy for the load and the working space

The B6350 is a service jack with a 7,000 lb rated capacity. Its 28.5-by-13.75-inch body footprint is also part of the purchase decision: allow room to position and operate the jack on a suitable surface.

Body height is not the same measurement as minimum saddle height. Do not use the 6.5-inch body dimension to decide whether the lifting saddle can enter beneath a particular car.

Position the saddle at the approved point

The swivel saddle helps with positioning, but the correct lifting point comes from the vehicle’s instructions. A convenient flat-looking area is not automatically a safe load-bearing point.

Do not exceed the capacity or modify the jack to reach a point it cannot safely access. A safety valve is not a substitute for selecting the right equipment and setup.

The manual requires separate support

Blackhawk’s operating instructions require appropriately rated jack stands rather than working on, beneath or around a load supported only by the hydraulic jack. Plan the support locations before lifting.

Choose the Arcan A20019 when its verified low-profile range better matches the access requirement and its 3-ton capacity meets the task. If either jack cannot meet the load, access and support requirements together, choose neither.

Compare the alternative

Arcan A20019: The A20019 is a 3-ton aluminum floor jack with a 3.75-inch minimum and 18-inch maximum saddle height. Consider it when those dimensions and its reach suit your approved lifting points.