Arcan A20019: features, fit and setup

The A20019 is a 3-ton aluminum floor jack with a 3.75-inch minimum and 18-inch maximum saddle height. Consider it when those dimensions and its reach suit your approved lifting points.

By GearMyRide Editorial Team · November 17, 2026
Research-based advice · How we pick

Arcan A20019

Low profile does not mean universal fit. The jack body still needs clearance, and the raised vehicle needs appropriate support equipment.

SpecificationDetail
Rated capacity3 tons / 6,000 lb
Minimum saddle height3.75 inches
Maximum saddle height18 inches
ConstructionAluminum with reinforced lift arm

We may earn a commission from qualifying Amazon purchases.

See Arcan A20019 at Amazon

Will a floor jack fit—and where will the stands go?

Use the height range to narrow the choice

A 3.75-inch starting height is useful for lower lifting points, but check the whole path beneath the vehicle. The saddle may fit at the edge while the jack body cannot reach the designated point farther in.

At the other end, 18 inches must be enough for the planned lift and stand placement. Do not add improvised blocks or extensions to compensate for an inadequate range.

Capacity and construction answer different questions

The 3-ton rating defines the load limit for the jack’s intended use. Aluminum construction affects handling and equipment choice; it does not increase the rated capacity or remove the need for a suitable floor.

Confirm the load and lifting arrangement from the vehicle’s instructions. A generic car, SUV or truck label is not a vehicle-specific approval.

Plan support before lifting

Have appropriately rated stands and approved support points ready. Never work beneath a vehicle supported only by this hydraulic jack. Inspect equipment and use the required firm, level surface.

The Blackhawk B6350 is the alternative to investigate if the task requires a 3.5-ton service jack. Its higher capacity still does not establish the clearance or reach your vehicle needs.

Compare the alternative

Blackhawk B6350: The B6350 provides a 3.5-ton rated capacity and a swivel saddle for positioning. Consider it for a suitable service setup when the lifting task requires that capacity.