What pressure should you set on a tire inflator?
Use your vehicle’s recommended cold tire pressure, not the tire sidewall maximum or the inflator’s maximum PSI.
Find the target for the tire you are filling
Read the vehicle’s Tire and Loading Information label, commonly in the driver-door area, or the owner’s manual. Front and rear targets may differ, and the spare can have a separate specification.
If the vehicle has a special load-dependent setting, use the applicable vehicle guidance. Do not copy another car’s number simply because the tire looks similar.
Match the units before pressing start
Inflators may display PSI, bar or kPa. Set the same unit as the target you are using. As a conversion example, 35 PSI is approximately 241 kPa or 2.41 bar; that example is not a recommended pressure for every car.
Read the existing pressure with the chuck fully connected. A poor valve seal can leak air and make the displayed value unstable. Reconnect it before continuing.
Check cold pressure when practical
Driving warms tires and changes pressure. Check tires cold, after the vehicle has been parked for at least three hours. Do not bleed a warm tire down to a cold target merely because its reading has risen.
If a tire seems low during a trip, follow the vehicle’s guidance and recheck it cold. A repeated loss deserves inspection rather than treating every warning as a routine top-up.
Confirm the result and stop for damage
Set the inflator’s target, start the correct tire mode and remain with it. Observe the pump’s operating and cooling limits. After it stops, verify the pressure with a suitable gauge and refit the valve cap.
Do not use pressure alone to decide that a damaged or previously flat tire is safe. Bulges, visible damage, rapid pressure loss or a tire driven flat need professional attention.
