Schumacher SJ1332: is the AC inverter worth the bulk?
A jump starter, tire compressor and low-power AC supply in one unit. Choose it for the outlets and inflator—not for a small glovebox kit.

Consider it when a modest AC load or a mattress inflator is a real part of your kit. Skip it if you only need compact starting and occasional tire top-ups.
We may earn a commission from purchases through our links, at no extra cost to you.
Check PriceWhat you get
| Specification | Details |
|---|---|
| Starting system | 12V lead-acid vehicles; 1,200A peak |
| Internal battery | Sealed lead-acid AGM |
| AC output | Two 120V outlets; 200W continuous total / 400W surge |
| Waveform | Modified sine wave |
| Air tools | 150 PSI compressor; separate high-volume inflator/deflator |
| Other outputs | 12V accessory power and USB-A |
| Charging equipment | Built-in AC charger; extension cord not included |
Starting a vehicle with the SJ1332
Use it only with a compatible 12V starting system and with the vehicle battery installed. The 1,200A peak figure alone does not establish an engine-size fit. Confirm that your vehicle permits external jump starting and follow its designated connection points.
Crank for no more than eight seconds per attempt, then wait two minutes before trying again. Turn the switch off after starting, disconnect in the specified sequence and recharge the unit. Follow the jump-starting preparation and connection guide alongside the vehicle-specific instructions.
Two outlets share one 200W limit
The 400W figure is a surge rating, not continuous power from each outlet. Add the connected loads before choosing the SJ1332. A heater, kettle or other appliance whose input exceeds 200W is outside its continuous limit.
For example, two devices with 65W and 40W AC input ratings total 105W. Replacing the 40W device with a 150W load makes 215W, above the limit. These are example loads, not measured runtime: starting surge and modified-sine-wave compatibility still have to fit.
Check the appliance’s AC input requirement, not just its USB output rating. If it requires a pure-sine-wave supply, choose a different power source. For overnight loads, check the required runtime and choose a power supply with verified capacity for that job.
The tire compressor and mattress inflator do different jobs
Use the pressure compressor and tire hose for compatible tires. The larger inflator/deflator hose moves air into or out of low-pressure inflatables. A 150 PSI limit does not turn the mattress connection into a tire pump.
Watch pressure and switch the compressor off at the required target. Its thermal protection can stop the motor and restart it after cooling; that is different from target-pressure shutoff. Stay with the unit rather than treating a temporary stop as completion.
It needs a regular charging routine
Charge after purchase, after use and every 30 days. The built-in charger still needs a suitable extension cord, which is not supplied. Keep the battery maintained even if the unit mostly sits in the garage.
Allow room for the complete unit and hose kit rather than planning around a small lithium pack. Carrying it is a different task from slipping a compact starter into a bag. Keep the clamps secured on their holders when using its power outlets.
When a lithium combo makes more sense
If your devices charge over USB and you do not need an AC socket, the WOLFBOX MegaVolt24 Air gives you bidirectional USB-C in a lighter-format kit. The NOCO AX65 is another option for an integrated hose and USB-C power.
See all five recommended jump starter and compressor combos before choosing the SJ1332 simply for its feature count.
